ProtiAnts
1. Drill diameter
- All drill diameter from 0.4mm (0.2mm by series production) in steps of 0,1mm are available.
- Plated-through holes are drilled approx. 0.1mm larger than the final diameter specified (the final diameter is achieved by the plating).
- If this increase is considered in the design, this should be specified in the order.
- For component holes, annular rings have to be made larger.
- You have to output separete Drilling program for PTH and another one for Non-PTH.
- Holes with a final diameter from 6.00mm are milled.
2. Annular rings
- Annular rings by plated holes:
- To ensure a surrounding annular ring around the holes, the following parameters in the layout should be observed.
- Annular rings by non-plated holes:
